MKS Gen V1.4 Printer Controller Board + 5 Stepper Driver Modules + Heatsinks
This is the latest MKS Gen V1.4 Printer Controller Board. A combination of the Arduino Mega R2560 and Ramps 1.4 board. We now have the V1.4 available in South Africa! This is also equipped with 5 Stepper Driver Modules and heatsinks.
- Mega 2560 and ramps1.4 set on a board, to solve complicated Ramps1.4 combination of interfaces, the problem of failure is prone.
- Replaces the motor drive, drive and support 4988 8825 drive.
- Circuit board with high-quality 4-layer, heat and made a special optimization; ramps are 2 shelves.
- It is now using high-quality MOSFET, and better heat dissipation.
- A dedicated power chip, support 12V-24V power input, the voltage converter chip to solve the heat problem Ramps.
- Supports 24V input power under the same system can be hot-bed current is reduced to 1/4, an effective solution to the hot bed MOS pipe heat problems.
- Firmware can use open source firmware Marlin, ramps1.4 identical configuration and can directly replace Ramps1.4.
- Reserved Ramps1.4 on Servos, AUX-1, AUX-2 interface that provides three 5V output, three 12V outputs.
Please Note: Locally stocked, Available for immediate shipping!